It is kind of a rainy day here in New Jersey and I had some slack time at work.
Well not really but I made some. It has been really quiet around here so what the heck I might as well try to revive the school of the boat with something simple The Log.
The Log is up in the Forward Torpedo Room so I kind of had to full around with it at times. Down then up, then down again only to have to raise it again. That was the life of operating daily ops.
To start with I added one screen shot of the values used to secure, vent, and operate the log. Each value had to be in the correct position for the Log to operate. The diagram I added shows the Log in the Secured position, so that's a freebie.
Question 1:
List the position of the valves in the 1) Surface Venting position; 2) Operating position; 3) Operating on Static Head position.
Question 2:
Which switches must be turned on to power the Log?
Question 3:
The Speed pointer indicates approximately 6 1/2 knots regardless of changes of ship's speed. What are possible causes? How do you correct the problem(s)?
Question 4:
The Log components operate correctly but excessive error of speed and distance indications at all speeds is noted. What are the possible causes? How do you correct the problem(s)?
OK this should take about 10 minutes of your time. Hey Darrin come forward - new Gilly! Bring some bug juice and a cup of Joe! I'm off watch for a while.
I forgot the bonus question. Operating the Log in the Static Head position is a means to check the components to see if everything is operating as if you were moving. So --- When operating in the Static Head position what will be the speed indicated?
Now have fun.